MG1CS111

All solutions listed below only run on supported firmware

Active Grill Shutter: *IMPORTANT* GRILL ACTUATOR PLUG MUST BE DISCONNECTED

Boost Sensor Calibration: 4BAR CALIBRATION

Checksums: AH38 - BOSCH MDG1 SPC5777M / TC2xxTP

Cold Start Noise:

DTC: NO UNPLUGS REQUIRED

Evap: *IMPORTANT* EVAP PURGE PLUG MUST BE DISCONNECTED

GPF/OPF: *IMPORTANT* OPF/GPF/PPF PRESSURE AND TEMPERATURE SENSORS MUST BE DISCONNECTED

Lambda: *IMPORTANT* PROBE MUST BE DISCONNECTED

Launch Control: LAUNCH RPM SET POINT IS ALWAYS SET TO 3000RPM

Readiness:

Revlimiter: RPM SET-POINT IS AT 6000

SAP: *IMPORTANT* ACTUATOR PLUG MUST BE DISCONNECTED

Speed Limiter: NO UNPLUGS REQUIRED

Start Stop:

Swirl Flap: *IMPORTANT* ACTUATOR PLUG MUST BE DISCONNECTED

Limp Mode:

Start Stop Inverted: RE-ACTIVAE BY PRESSING START STOP BUTTON