Get In Touch

[email protected]

Login
Contact

MED9.1.1

Notes for all supported solutions

All solutions listed below only run on supported firmware

Boost Sensor Calibration: 4 BAR CALIBRATION
Checksums: AH74 - BOSCH MED9.1 MPC562
Cold Start Noise:
DTC: NO UNPLUGS REQUIRED
Evap: NO UNPLUGS REQUIRED
Lambda: *IMPORTANT*  PROBE MUST BE DISCONNECTED
Revlimiter: PRM SET-POINT IS AT 6000
SAP: NO UNPLUGS REQUIRED
Speed Limiter: NO UNPLUGS REQUIRED
Swirl Flap: *IMPORTANT*  ACTUATOR PLUG MUST BE DISCONNECTED
Fuel Pump Calibration: UPGRADED HIGHE PRESSURE FUEL PUMP WITH 11.4MM PISTON